SLA009A Solas Aluminum Impeller Seal


1. Remove and separate the whole jet pump from the PWC.

2. Remove the trail cone (or cap) from the stator.

3. Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench (optional part). Turning counter clockwise will loosen the impeller.

4. Visually inspect thread on shaft & impeller for debris or damage. Apply grease or anti-seize on the thread before installation.

5. Screw in the impeller by hand; please be careful of the sharp edgas of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.

6. Assemble the pump and put it back on the PWC.

*This installation guide is suggested for reference only. (Please refer to your original service manual or contact your PWC Dealer for detail.)

Availability: Available
Part #




YG (Dynafly Series)

YH, YJ (Concord Series)

YF (Xprop Series, Concord Series )


KX, KR, KGX (Concord Series)

KD (Super Camber(ABC Series))

KG (Xprop Series, Concord Series)

KP (Concord Series, Dynafly Series)

KF (Super Camber(IJK Series), Xprop Series)

KA (Super Camber(ABC Series), Super Camber(IJK Series))

KE (Super Camber(ABC Series), Super Camber(IJK Series), Xprop Series, Concord Series)

Write Your Own Review
You're reviewing:SLA009A Solas Aluminum Impeller Seal
Your Rating
Save Money
We have the best WSM prices in Australia, and we will match any written quote. Call us today 07 5531 3855
Can’t Find a Part
If you can't find the wsm part you are looking for please give us a call as we will probably have it in stock.
Super Fast Delivery
We use the fastest couriers in the business, want your part fast? Choose WSM Parts for PWC, Jetski, ATV, Dirt Bike, Jet Boat and Outboard Motors